Fault codes ahoy!

[Wazzzer]

Just picked these up off the Golf, I'm assuming and hoping they are down to the clocks being changed?

Address 01     -------------------------------------------------------
   Controller: 06A 906 018 CG
1 Fault Found:
17978 - Engine Start Blocked by Immobilizer
            P1570 - 35-10 - - - Intermittent

Address 17     -------------------------------------------------------
   Controller: 1J0 920 926 A 
   Component: KOMBI+WEGFAHRSP VDO V02
   
10 Faults Found:
00771 - Fuel Level Sensor (G)
            30-10 - Open or Short to B+ - Intermittent
01039 - Coolant Temperature Sensor (G2)
            29-10 - Short to Ground - Intermittent
00562 - Sensor for Oil Level/Temperature (G266)
            30-10 - Open or Short to B+ - Intermittent
00779 - Outside Air Temp Sensor (G17)
            30-10 - Open or Short to B+ - Intermittent
01128 - Immobilizer Pickup Coil (D2)
            35-10 - - - Intermittent
01176 - Key
            07-10 - Signal to Low - Intermittent
01314 - Engine Control Module
            49-10 - No Communications - Intermittent
01316 - ABS Control Module
            49-10 - No Communications - Intermittent
01321 - Control Module for Airbags (J234)
            49-10 - No Communications - Intermittent
01336 - Data Bus for Comfort System
            49-00 - No Communications

Address 19     -------------------------------------------------------
   Controller: 6N0 909 901   
   Component: Gateway K<->CAN    0001

5 Faults Found:
01314 - Engine Control Module
            49-10 - No Communications - Intermittent
01316 - ABS Control Module
            49-10 - No Communications - Intermittent
01321 - Control Module for Airbags (J234)
            49-10 - No Communications - Intermittent
01336 - Data Bus for Comfort System
            49-00 - No Communications
01331 - Door Control Module: Driver Side (J386)
            49-10 - No Communications - Intermittent

Now they've all cleared off apart from this one which seems to come back all the time, it this cos I still have an immo2 CCM and not the immo3 version?

1 Fault Found:
01336 - Data Bus for Comfort System
        49-00 - No Communications

[jamie1989]

Haha beat my list mate, Worse iv seen is about 3 or 4 codes 

Best one is Engine warranty VOID max speed exceeded lmao 

[scarr89]

That is an awful lot of codes. I'd probably drive to the scrappy now...save you getting a tow 

[dan2252]

id say most of them are due to stuff been unplugged when you did clocks or whatever, try clearing them all and seeing what comes back,

[golfyste]

Haha beat my list mate, Worse iv seen is about 3 or 4 codes 

Best one is Engine warranty VOID max speed exceeded lmao 

With a little "" at the end haha

[GTi_James]

isnt that pretty much all the sensors? 

[Wazzzer]

Found the problem. All the codes apart from the last one are down to changing the clocks over. The last code is my fault for not clearing out the can gateway soft coding. It was the same as my old clocks so I just left it as it was but you need to clear and re enter the coding to get it to re sync. It was stalling straight after I started it up too but all sorted now