S3 inlet fit a 1.8T mk4 ?

[Toby]

yours AGU? 

then saab reds will work!

get a badger 5 tip aswell 

[golf-sib]

The injectors for your AGU are EV6 type fitament which are low impedance (1.2 Ohm) versus the TT/S3 injectors which are EV12 type and high impedance (12 Ohm)

In short I'd look else where for injectors, Calibra yellow's come to mind 

[p4sty]

Right ok so s3 don't fit ?
Do you know off hand a list of injectors I could go for ? Looking for 440cc most probably but want to keep cost fairly low :-) .. In regards to the maf can I use an s3 one ?

And yep an AGU motor .. Think I'm going for a b5 tip herd very good reviews !!

[golf-sib]

Right ok so s3 don't fit ?
Do you know off hand a list of injectors I could go for ? Looking for 440cc most probably but want to keep cost fairly low :-) .. In regards to the maf can I use an s3 one ?

And yep an AGU motor .. Think I'm going for a b5 tip herd very good reviews !!

Yep use s3 MAF

Look above two injectors already suggested 

[rio_gti]

thnk you can also use vxr ones too 

[Toby]

Shape u want

[p4sty]

So what cc are vxr injectors ?
And what cc are the above injectors ?
Sorry not very clued up :-/

[p4sty]

Also Toby does the relentless manifold fit straight on ? Was looking into the Downpipe and Decat but not sure if they will fit !!??

[rio_gti]

vxr are 480cc

toby whar are the reds??!!!

[Toby]

So what cc are vxr injectors ?
And what cc are the above injectors ?
Sorry not very clued up :-/

380? Or 440? I can't remember but there Saab reds!!

Manifold is bolt on. But what a thingy! Allow a few hrs lol