« on: 02 October 2011, 05:10 »
Okay, it has been a good while since I fitted the RNS to my last mk6, and that car didn't have Dynaudio or Bluetooth.
Last time round it was just a matter of bolting the thing in and enabling the 'BAP' in VCDS. Not that I can remember how I even did that bit, thankfully Morty gave me idiot proof instructions with the unit at the time.
So this time round I have factory Bluetooth and Dynaudio to contend with when fitting my early model RNS (no star button) that is running 27** software.
I've asked a mate from another forum if I can once again make use of his VCDS and thus wonder if anyone can give me an idiot proof guide as to what bits I need to code in and what should work automatically before I start the install.
There are bound to be loads of changes to the electronics of the later model car (this car doesn't even give be a bulb out warning with my LED tails!!) on top of the other factory additions specced on this model.
Hell, I expect his VCDS is running later firmware than last time round too as I'm sure it looked different the other week when I recoded the lights back to non-LED mode before the old car went in part-ex.
Also, are there any other recommended little tweaks I can make whilst I've got the VCDS cable in my sweaty hands? Staging was one that sprung immediately to mind

so what else have I forgotten over the last few years?

Logged
‘26 Ed50, ‘23 Leccy Mini, ‘25 8.5R, ‘23 8R, ‘20 8CS, ‘19 135iX, ‘19 TCR, ‘17 Ed40, ‘17 GTD, ‘15 7R, ‘13 GTI PP, ‘11 GTI, ‘09 GTI, ‘98 Ibiza Cupra, ‘05 GTI, ‘06 Polo GTI, ‘04 GT TDI, ‘05 Fabia vRS, ‘02 GTI T, ‘03 Ibiza TDI 130, ‘01 Leon 180, ‘89 mk2 16v, ‘99 Ibiza TDI, ‘96 VR6, ‘98 Ibiza TDI, ‘92 VR6, ‘88 mk2 8v, ‘92 Polo G40, ‘91 mk2 8v, ‘89 mk2 8v, 205 GTI 1.9, ‘83 mk1 GTI, ‘80 Scirocco GTI, plus some others I’ve forgotten