any extra oomppff??

[player.777]

Guys, my old man is coming over from Oz in three weeks and he hasn't been in the car since the re-map. I have dropped a bottle of Forte treatment in, but what else can I do, or book in for, to give it any extra BHP it may be losing??  To give it a little tweak before he has a go?

[Rhyso]

Innotec Turbo Cleaner

Replace all o-rings and clip fittings

Turbo back exhaust

How deep is your wallet? 

[player.777]

thanks mate- i take it the turbo cleaner in question is this one? http://www.innotecworld.com/c-1064-turbo-clean-set.aspx  Did it make any difference you reckon?   I have checked and replaced a few clips a while ago, will have another look and see. can't afford a new exhaust now- am moving house this friday (aagghh!!) so all money (and a lot more) tied up in that.

[Rhyso]

thanks mate- i take it the turbo cleaner in question is this one? http://www.innotecworld.com/c-1064-turbo-clean-set.aspx  Did it make any difference you reckon?   I have checked and replaced a few clips a while ago, will have another look and see. can't afford a new exhaust now- am moving house this friday (aagghh!!) so all money (and a lot more) tied up in that.

That's the stuff

I find my car smokes a lot less since having done it - got another issue so can't really comment on its full benefit but others have had it done and comment that the engine is far more responsive 

I know Steve did it on his and he hasn't (not to my knowledge) hit limp mode since.  Having been out in his car last week I can confirm its proper quick

Not much more you can do then apart from check fluid levels and tyre pressures etc

Also make sure your wheel alignment is spot on to aid cornering and sure-footedness
NOt much more you can do then

[player.777]

ok great, i'll call up and get that ordered tomorrow. cheers bud

[Rhyso]

ok great, i'll call up and get that ordered tomorrow. cheers bud

you got a garage who can do it?? Otherwise it will mean lying flat on your back wiggling your actuator 

[player.777]

ahhh bugger- is it not a DIY job then?? 

[Rhyso]

ahhh bugger- is it not a DIY job then?? 

not really know unless you get a decent jack and axle stands

you need to remove the downpipe off the turbo as you inject the cleaner directly into it

Its an hour's labour

[player.777]

ok.... decent jack- uncheck, axle stands- uncheck, fine I'll get someone else to do it!!!!!

[Rhyso]

ok.... decent jack- uncheck, axle stands- uncheck, fine I'll get someone else to do it!!!!!

wise move    Make sure they replace the gasket between the turbo and downpipe - about £3 from the dealers