Author Topic: Tapping or what?  (Read 1144 times)

Offline Malz0r

  • Here all the time
  • ****
  • Posts: 315
  • Haters gunna hate.
Tapping or what?
« on: 27 September 2006, 13:10 »
okay when i go up hill or the car is under load (normally just up hills) i get this faint tapping noise infront of me, but when you ease the accelorator it goes untill i put more power down? i searched the site found it may be tappets or is it something else? can i drive it okay for the moment? its not very loud but it does annoys the hell out of me, been doing it for abit a week so will it be okay for the moment? i hear valvers tap abit anyway? true or not?

anything helpfull would be great! Thank you!

Judderi

  • Guest
Re: Tapping or what?
« Reply #1 on: 27 September 2006, 13:48 »
It could be the timing chain. Over the years they get loose and make a noise.

Offline Len

  • 10k hero
  • *
  • Posts: 16,298
  • Guardian of the Seas, Protector of Waves
Re: Tapping or what?
« Reply #2 on: 27 September 2006, 14:36 »
Could be tappets/timing chain or possibly big ends!
Mystic Blue Mk3 16v + Black Mk5 Gti 05 plate + Peugeot 405 Mi16

www.sas.org.uk
www.the-ace.org.uk

Offline Stu.750

  • I live here
  • *****
  • Posts: 1,843
  • MMMMMMM Rust my favourite
Re: Tapping or what?
« Reply #3 on: 27 September 2006, 14:48 »
sounds most probably tappets , does the tapping get faster if you continues to accelerate ,

 big ends are more of a rattle than a tap id have said 

Judderi

  • Guest
Re: Tapping or what?
« Reply #4 on: 27 September 2006, 15:39 »
My timing chain only rattled when under load. Bearings will do the same usually. Tappets seem to tapp all the time when dodgy.

Offline Malz0r

  • Here all the time
  • ****
  • Posts: 315
  • Haters gunna hate.
Re: Tapping or what?
« Reply #5 on: 27 September 2006, 17:05 »
it stops tapping after you ge over 4k revs an it drives like normal a,d idle just fine only when pulling up hills?

Offline Stu.750

  • I live here
  • *****
  • Posts: 1,843
  • MMMMMMM Rust my favourite
Re: Tapping or what?
« Reply #6 on: 27 September 2006, 17:53 »
They are hydraulic tappets arnt they  ?

 if so it could be somethin to do with your oil level or oil pump , bottom end bearing rattle wouldnt stop over a certain revs

Offline Malz0r

  • Here all the time
  • ****
  • Posts: 315
  • Haters gunna hate.
Re: Tapping or what?
« Reply #7 on: 27 September 2006, 22:56 »
oil was done less that 500 miles ago, so looks like tappets they dont do it much but will have some take a look to be sure :) thanks for your help!

Offline vwagain

  • Here all the time
  • ****
  • Posts: 299
Re: Tapping or what?
« Reply #8 on: 27 September 2006, 23:44 »
1996 2.0l 8v, black magic pearl paint<br />