Rocker and inlet bolts

[Nino]

Hey giys just wondered if anyone knew what the bolts on the rocker cover and the bolts on the inlet had to be fully torqd at and in what order they need to be tightened in and in what process e.g must i torq the bolts to a cetain spec all round then go back in a certain order to fully tighten?

[limmy]

This is what i used:

Inlet Manifold - bolts to block - 6Nm
Rocker cover - nuts to block - 10Nm

Regarding sequence, have a look at thoses DIY guides i sent you awhile back as i think its mentioned in there

[Nino]

Thanks a lot ill see if I can find it

[jamie16v]

whilst on this topic, anybody know the best place to get new injector seats and how much they are?
cheers.

[mike1990]

According to my AutoData, it says the rocker and inlet are both 10Nm.

Tighten them in a sequence starting in the middle and work your way to through them from left to right and right to left

[Nino]

whilst on this topic, anybody know the best place to get new injector seats and how much they are?
cheers.

I got mine from a supplyer on ebay see here....
http://www.ebay.co.uk/itm/181164148399?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#ht_350wt_1141

[Nino]

According to my AutoData, it says the rocker and inlet are both 10Nm.

Tighten them in a sequence starting in the middle and work your way to through them from left to right and right to left

Thanks for that info

[mike1990]

According to my AutoData, it says the rocker and inlet are both 10Nm.

Tighten them in a sequence starting in the middle and work your way to through them from left to right and right to left

Thanks for that info

No problem

[jamie16v]

whilst on this topic, anybody know the best place to get new injector seats and how much they are?
cheers.

I got mine from a supplyer on ebay see here....
http://www.ebay.co.uk/itm/181164148399?ssPageName=STRK:MEWAX:IT&_trksid=p3984.m1423.l2649#ht_350wt_1141

they no good for the large port head?.. (AGU)

[Nino]

Does anyone also know what gasket sealent I could buy from eBay and where to apply it on the rocker cover gasket?