« previous next »
Pages: [1]

Author Topic: sai help please  (Read 1009 times)

Offline streetbeef

  • Not said much yet
  • **
  • Posts: 60
sai help please
« on: 19 September 2012, 10:37 »
Last week i removed the sai and all associated bits and bobs and fitted the forge blanking plate. Problem is now i know that the ecu will store the low flow rate code. But i was under the impression it wouldnt bring up the management light  :undecided: i also have a resistor fitted to the plug that went to the pump. I clear the code but the light always comes back on 2 days later. Any adice would be great.
Logged
2000 indigo blue golf gti AUM, full oe r32 kit, xenon headlights, r32 wheels, r32 interior trims,steering wheel,pedals and foot rest, h&r springs, r32 milltek cat-back, stage 1 remap, forge diverter valve.

Offline Dalo Harkin

  • I live here
  • *****
  • Posts: 2,070
Re: sai help please
« Reply #1 on: 19 September 2012, 12:30 »
which resistor did you use?
did you solder the wires of choc block them?
Logged
ARZ K03s, Oettinger Side Skirts, R32 front, Carbon stage 2, Forge 007p (yellow spring), Forge Actuator (yellow spring), Pipercross panel filter with DSG parts, N249 and N112 deleted, SAI deleted, Carbon canister deleted, Rear wiper deleted, Long Life turbo back custom exhaust with 200 cell sports cat, VR6/G60 clutch kit, Creation Motorsport TIP, Catch can, 'Wellycooler', K04 charge pipe, S3 ported inlet manifold - looks pretty standard on the outside though :)

Offline JimBR

  • I live here
  • *****
  • Posts: 569
Re: sai help please
« Reply #2 on: 19 September 2012, 16:19 »
You can get it mapped out by R-Tech/Shark or the likes.
Logged

Offline streetbeef

  • Not said much yet
  • **
  • Posts: 60
Re: sai help please
« Reply #3 on: 19 September 2012, 18:36 »
i think it wasd a 330w 10ohm resistor iirc..  its just strange because my friend has a mk3 ibiza cupra and has done the exact same thing and his eml hasnt come on once  :sad:
Logged
2000 indigo blue golf gti AUM, full oe r32 kit, xenon headlights, r32 wheels, r32 interior trims,steering wheel,pedals and foot rest, h&r springs, r32 milltek cat-back, stage 1 remap, forge diverter valve.

Offline Mr_Orange

  • I live here
  • *****
  • Posts: 2,209
  • MK4 GTi Turbo Exclusive 150 AUM
Re: sai help please
« Reply #4 on: 20 September 2012, 19:16 »
Even with a resistor the AUM will throw incorrect flow code with CEL on dash.  Have a word with R-Tech, it can be mapped out of the emissions readiness check code.
Logged


Build thread clicky
Pages: [1]
« previous next »