Loads of people say you need to disconnect the brake lines which you dont quick step by step from what i can remember
Get the wheels off and put it on axle stands
Unclip the hard brake lines the just push out from the clips
Theres a little bracket where theres a join in the lines cut a slot in the bracket big enough to slide the smaller pipe out
Remove calipers and tie them to the shock or something but dont bend the lines
Put a jack under the beam to support it
Undo shock bolts
Undo rear beam bolts the go through bushes
Lower jack a bit and remove the beam
DEFFINITLY A 2 PERSON JOB !
