PLEASE HELP URGENTLY!!!!!!!!!

[(shakey)]

taking the sump off and the last bolt remove in by the gearbox has rounded off and cant get it off,any HELP will be very very greatfull.


THE BOLT THIS WELL STUCK AND VERY TIGHT IS THERE A SPECIAL SOCKET I CAN GET 

[rio_gti]

10mm socket or I think 6mm alen key should do it

[(shakey)]

10mm socket or I think 6mm alen key should do it

no good m8 tryed that already its on a slight angel and socket wont quite fit on and its rounded the bolt head and the allen has rounded to as the bolt is so tight 

[(shakey)]

BUMP STILL NOT GOT IT OFFFFFF HELPPPPPPPPPPP

[houston]

use a smaller socket and hammer it on, obviously replace the bolt

[(shakey)]

use a smaller socket and hammer it on, obviously replace the bolt

its hard to get a smaller socket as its on a slight angel so the socket wont sit right.

[jonnyturbo]

What about a bolt extractor socket

[(shakey)]

What about a bolt extractor socket

that might work will have to get 1 tomorrow i have spent allday trying to fricking bolt out 

[opel]

if not smack a multispline bit into it and try to get it out if not it may be a gear box out job to get to it properly

[houston]

use a smaller socket and hammer it on, obviously replace the bolt

its hard to get a smaller socket as its on a slight angel so the socket wont sit right.

put the socket on extension bar and hit it that way, if by angle you mean you have to put socket on at angle?

other than that other choice is weld another bolt to it, mole grips, grind it and use stud extractor for remaining bit