I haven't had a Saturday off to fit my Bilstein/Eibach setup until this weekend so before I tackled it I need a bit of advice on the little things. So far I have:
Genuine front and rear top mounts with bearings
Genuine rear bump stops
The Bilstein kit came with front dust covers and nuts/bolts for front and rear.
However the assembly instructions show rear bump stops but not fronts. I checked my existing standard setup and it was impossible to see but thought I felt it through the rubber cover. Is there a front bump stop? Surely there has to be but it seems quite small if it is! The Bilstein front damper part is quite thick so I don't even know if a standard front bump stop would fit over it.
Also spring pads, the standard setup doesn't have them for the bottom and can this cause a noise issue?
Appreciate any advice and tips on doing it. I will have my ramp at work and my impact gun to shear bolts off

but it looks quite straight forward... he says