TPMS - Retro-Install - final stages - HELP!

[Buck]

Hi guys

finally got round to installing the above (loom provided by SteveP)

I have the yellow wire through the bulkhead grommet and now need to fasten the pin into the ABS controller behind the battery - which I have removed after taking the battery out - so far so good.

In the instructions it says to unlock the connector using a screwdriver - I have done this but then what?

How do I gain access to the rear of the connector block to insert the new cable into 35 pin? or am I missing something?

Car is currently "disabled" whilst I work this out so any help appreciated!

Thanks

[mike.]

You need to unclip the backshell from the connector to enable you to push the wire in from that side..

[Buck]

It's this bit where I've got myself stuck!



I've unlcoked the connector but without breaking the housing what do I do to get access?

[Buck]

Thanks Mike

I can see a hole for the wire with a rubber bung/plug in it - just remove this? then slide the wire through?

[mike.]

Yes, you can use a cocktail stick or something like that to push it out from the other side.

[Buck]

Yes, you can use a cocktail stick or something like that to push it out from the other side.

Good man!

Off back down to the garage to have another go - will be back to update in a while 

[Buck]

Thanks Mike

Wire in, connector back on etc. Just to code now when I get access to VCDS.

Adrian

[mike.]

Great stuff Adrian, glad to be of help 

[Snoopy]

Any chance of some photos as i have mine to do at some point too and the more info the better really.

[Buck]

Geoff

I've fully reassembled mine now but if I can get some shots and words to support Steve's guid I will do. 


Adrian