project neg new wheels page 30

[lemski]

Got a few people who I can use there ramps. Its cheaper to do it your self. Just cost beer tokens.

[lemski]

we'' today i put my numberplate back on bumper and tightened the exhaust mount. weather is stopping me getting pics as its too cold for the likings of me but i'll update with pictures of it all when i next do something to the mk2

liam

[lemski]

Well. Big things happened today. I decided to get my 16s back on the car nxt weekend. But I want to keep it low and as the 16s are stupid offset they sit at the edge of the arches. So I'd have to raise it. Well I thought about this and decided am going to roll my arches. Backs were ground back to make sure no rust then heat gun and a hammer by my mate ian to got the lips bent in and a slight pulling with a scafold pole. Sorted.
For the fronts I decided that I wanted a nice arch line and also wanted to still go low. So after getting a spare wint to replace mine that was rotted. I set about pulling the lip. (Towel and molegrips), as my technique wasn't good to begin with I had some dimples to sort. Easy though as the filler is needed to go on all arches to get things smoothed. Its not finished buts its good for now. I even lowed the front another 20mm and still got 20mm of clearence on the arch.
Pics up tomorow of all the arches and seats and other things I need to put up.
Cheers to martin and ian for the help today.
Cheers liam

[Peej1981]

mmm somebody has been a busy boy today, well done mate, look forward to the pics. What does it sit like now?? How low are running it?

[lemski]

Can u remember when it was at its lowest point on stealies about 10mm higher than that gunna set it low when 16s are on it.

[mk2 helper]

no wurries m8 was a good dai and neg has some awsome stance now and it'l be better with the 16's and i doubt it will rub m8 its all gravy baby

[lemski]

It won't with my new found arch pulling skills mate. Haha

[Peej1981]

Yeah i remeber mate it was fuc*ing low, good work then. Whe you aroung my area next? Managed to sort out the golf, bit of a bodge job but alls good and then when i get it into the workshop then will sort if properly and do the discs too, really need to update my thread  

[lemski]

Couldn't say mate at mine this weekend. Umm worki mon and tuesday. Then college. I could swing round wednesday morning befor college mate. Show you the neg. Might not have sprayed wing bu then but o we'll.

[Peej1981]

yeah that would be cool, i am sure i have seen neg in a worse condition