vagcom fault codes an issues,,, seriously not good :(

[linz]

well put my baby on the vagcom for first time and  (as since the upgrade she is just not running right at all she is barely driveable in fact) (im not happy an want it sorted)
some of her problems link to what vagcom said others im baffled the whole car seems to shake uncontrollably at like 40mph 


anyway...
oh dear seems i have like 6 engine faults that all lead to maf sensor so guessing i should get a new one.. do i just replace or shud i get the vr6 one as i no i need tht for my live map.
also when upgrading to i get the vr6 housing n sensor or just the housing with a 1.8t sensor?? :embarassed: and do i simply swap them over an thats it?

also i got up like 17 fault codes for central locking  havent got a clue what they are all about either

[richw911]

Have you got a copy of all the codes? 

[linz]

right rich remember you asked for it 

engine fault codes -
 Faults Found:
17967 - Throttle Body (J338): Fault in basic settings
            P1559 - 35-10 -  -  - Intermittent
16487 - Mass Air Flow Sensor (G70): Signal too High
            P0103 - 35-10 -  -  - Intermittent
00561 - Mixture Adaptation
            13-10 - Adaptation Limit (Mul) Not Reached - Intermittent
16505 - Throttle Position Sensor (G69): Implausible Signal
            P0121 - 35-10 -  -  - Intermittent
01262 - Solenoid Valve for Boost Pressure Control (N75)
            26-10 - Output Open - Intermittent
00561 - Mixture Adaptation
            14-00 - Adaptation Limit (Add) Exceeded

airbag codes -

2 Faults Found:
00532 - Supply Voltage B+
            07-10 - Signal too Low - Intermittent
01317 - Control Module in Instrument Cluster (J285)
            49-10 - No Communications - Intermittent

instrument codes -

2 Faults Found:
01039 - Coolant Temperature Sensor (G2)
            30-10 - Open or Short to Plus - Intermittent
01314 - Engine Control Module
            49-10 - No Communications - Intermitten

and the central convenience codes -

16 Faults Found:
00953 - Interior Light Time limit
            25-10 - Unknown Switch Condition - Intermittent
01330 - Central Control Module for Central Convenience (J393)
            53-10 - Supply Voltage Too Low - Intermittent
01329 - Convenience System Data Bus in Emergency Mode
            35-10 -  -  - Intermittent
01334 - Door Control Module; Rear Right (J398)
            49-10 - No Communications - Intermittent
01333 - Door Control Module; Rear Left (J388)
            49-10 - No Communications - Intermittent
01332 - Door Control Module; Passenger Side (J387)
            49-10 - No Communications - Intermittent
01331 - Door Control Module; Driver Side (J386)
            49-10 - No Communications - Intermittent
01331 - Door Control Module; Driver Side (J386)
            53-10 - Supply Voltage Too Low - Intermittent
00943 - Heated Exterior Mirror; Driver Side (Z4)
            35-00 -  -
01332 - Door Control Module; Passenger Side (J387)
            53-10 - Supply Voltage Too Low - Intermittent
01332 - Door Control Module; Passenger Side (J387)
            52-10 - Supply Voltage Too High - Intermittent
00944 - Heated Exterior Mirror; Passenger Side (Z5)
            35-00 -  -
01333 - Door Control Module; Rear Left (J388)
            53-10 - Supply Voltage Too Low - Intermittent
01333 - Door Control Module; Rear Left (J388)
            52-10 - Supply Voltage Too High - Intermittent
01334 - Door Control Module; Rear Right (J398)
            53-10 - Supply Voltage Too Low - Intermittent
01334 - Door Control Module; Rear Right (J398)
            52-10 - Supply Voltage Too High - Intermittent

[jeynesey]

All those door module ones look ominous

Did they show after you cleared them?

[Rhyso]

A lot of those simply look as if they've pulled the battery

What codes have come back since you cleared them?

[JC]

old carz rule 

[linz]

i did the vagcom like 2 days ago.. an 2 days later there still there im not to worried about the central locking ones im more wrrried about the engine codes


and the airbag one would be nice as the dash light being on is a pain

[Rhyso]

So you couldn't clear ANY of the codes? 

It looks to me that they've unplugged nearly everything and not plugged it back in 

[linz]

havent done anything about them to be honest 

as i said ive ignored the central locking ones it works that good enough for me.....

im more concerned about getting my car running right.... as right now its wat i would call undriveable

[Rhyso]

Have you cleared the codes though?   

i.e you've clicked the CLEAR DTC button in VAGCOM

Sorry to bang on about it but you're not being very clear if you've done that or not