« previous next »
Pages: [1]

Author Topic: What does it do?  (Read 1390 times)

Offline lukesGTI

  • Not said much yet
  • **
  • Posts: 28
What does it do?
« on: 27 April 2009, 19:11 »
I have installed a k&n induction kit on my 8valve but where do i put that round sensor that goes in the air filter box? i have disconnected it for the moment and miraculously my missfire problem is calmed down, could that sensor if naf cause a missfire?
Logged

Offline grimmer

  • Not said much yet
  • **
  • Posts: 95
  • www.check-light-on.co.uk
Re: What does it do?
« Reply #1 on: 27 April 2009, 19:47 »
that is the air intake temp sensor, dont really do alot to be fair, its normally the sensor that the dodgy ebay 10+bhp resistor thing goes across. best to just drill a small hole in the neck of the filter and push it in there.
Logged
MK3 GOLF GTI 8V  now converted to 16v!!

Offline Mikester

  • Forum addict
  • *
  • Posts: 6,427
  • Civic Type R
Re: What does it do?
« Reply #2 on: 27 April 2009, 21:22 »
NOOOOOOOOOOOOOOOOOOOOOOOOO!!!!

Dont do that.. Bad bad bad.

If the cone is the correct one for your car, it will have a hole already made in it for the sensor to push into, on the back of it.

I have a KN on an 8v, and it has the hole to put the sensor in.
Logged

kells

  • Guest
Re: What does it do?
« Reply #3 on: 27 April 2009, 21:41 »
must be different to early cars then as i have no sensors hanging and no holes in the K&N
Logged

Offline Mikester

  • Forum addict
  • *
  • Posts: 6,427
  • Civic Type R
Re: What does it do?
« Reply #4 on: 27 April 2009, 21:45 »
different MAF, so maybe the sensors is different.

All i know is, i have the sensor, and i have the hole to fit it. And i didnt find the hole at first, so do give it a propper going over before you destroy it with a drill, as they are expensive those KN's
Logged
Pages: [1]
« previous next »