Really sorry but a quick VAGCOM Question!

[m19ads]

Well seem to be able to use all of the functions mentioned above all sorted, just wanted to say thanks again!  I even had a fault code come up, just need to work out where to begin with repairing it lol!! I have posted in the Garage section but its the ineterior monitoring system 01135, open circuit 36-00 so if anyone happens to have any ideas then they would be greatfully received! 

[Steve_PD]

Ross Tech Wiki

 01135 - Interior Monitoring Sensors
01135 - Interior Monitoring Sensors: Open Circuit
Possible Causes

* Wiring/Connector from/to Interior Monitoring Sensors faulty
* Interior Monitoring Sensors not installed

Possible Solutions

* Check/Repair Wiring/Connector from/to Interior Monitoring Sensors
    o See Measuring Blocks
* Check Interior Monitoring Sensors Installation

 

[m19ads]

thanks for that, Rhyso has just replied on the thread in the garage section and suggested I look at the rear interior light unit and check the contacts in there so will take a look at the weekend! 

[Dan n Nic]

So, I have joined the club and also bought one of these, but I am also having problems getting it to work. The disc that it came with was unreadableso I Downloaded the software and have changed the com port, but when i click the test button  I get... Port Status: OK Interface: NOT FOUND??? (& yes it is plugged in LOL)

Any ideas?

[Steve_PD]

Does you laptop recognized the lead?? Is the driver installed??
If it is maybe a iffy lead 

[Dan n Nic]

Yeah, the "found new hardware" bubble popped up and I installed the drivers as per the instructions on the Ross-Tech website and the "LEDs" completed succesfully???

I may just uninstall and reinstall?

[Steve_PD]

Have you tired all the ports and the usb port??
It going to be simple if its all installed

[Dan n Nic]

Yep, tried different usb ports and com port. Same message.

[chrish22]

got mine working fairly quickly, if i recall you gave to go to the properties in device manager and change the emulated com port to a lower number.

mine installed as com port 11 initially, i changed it to com port 2 and sorted!

hth.

[Dan n Nic]

Yeah, mine installed on com port 13 so changed that to 2 and the message says Com Port: OK , but the Interface: Not found??? but the computer recognises that it has been plugged into the USB as I get the usual "ding ding" when a usb device is plugged in?