« previous next »
Pages: [1] 2

Author Topic: Door Adjustment  (Read 8296 times)

Offline Neil Horn

  • Not said much yet
  • **
  • Posts: 34
Door Adjustment
« on: 06 December 2003, 09:43 »
The common prolem of door bottoms starting to rub on the slls.  How easy is it to replace hige pins/adjust doors.  I am afraid f wrecking more than I fix.  Haynes comic jst says " Put em back on, adjust them and Roberst's your mothers Bruvver".  Any better advice/books/websites? >:(
Logged

Offline Neil Horn

  • Not said much yet
  • **
  • Posts: 34
Re:Door Adjustment
« Reply #1 on: 06 December 2003, 09:45 »
Wow, I've just read my post, how many letas did I mis, tok abut spilling arrars!
Logged

Offline dan

  • Not said much yet
  • **
  • Posts: 35
Re:Door Adjustment
« Reply #2 on: 06 December 2003, 15:55 »
 :)
Quality!

I have the same problem too on my Cabby nearside door, and you are right about the Waynes (Sorry Haynes) book, useless.
Logged

Offline Gambit

  • Forum addict
  • *
  • Posts: 4,354
Re:Door Adjustment
« Reply #3 on: 10 December 2003, 15:52 »
put a wheel stud in the bottom bracket of the door and gently close it, this will lift the door upward by resetting the sag in the bracket

dont close it too hard or it will over correct it

if you over correct it then still the wheel stud in the top hinge and this will lower.

just take it slowly bit by bit, checking after each squeeze!
Logged

Offline richandhazel

  • Global Moderator
  • Forum addict
  • *****
  • Posts: 4,464
Re:Door Adjustment
« Reply #4 on: 10 December 2003, 16:37 »
Do you know.........I knew there was a fix for this but I couldn't remember what it was, must be getting old. Well done Gambit.
Logged

Offline Neil Horn

  • Not said much yet
  • **
  • Posts: 34
Re:Door Adjustment
« Reply #5 on: 10 December 2003, 20:57 »
That's tomorrows job sorted.  I'll let you know how it goes.
Cheers.
Logged

Offline Neil Horn

  • Not said much yet
  • **
  • Posts: 34
Re:Door Adjustment
« Reply #6 on: 10 December 2003, 21:15 »
Gambit,
You da man!!!  Why wait 'til tomorrow, that took about 5mins.  Had an M10 bolt in the garage, found that worked a treat.  Door opens and shuts as smooth as silk now.
 ;D
Logged

Offline miguel

  • Not said much yet
  • **
  • Posts: 70
Re:Door Adjustment
« Reply #7 on: 11 December 2003, 09:59 »
Quote from: Gambit on 10 December 2003, 15:52
put a wheel stud in the bottom bracket of the door and gently close it, this will lift the door upward by resetting the sag in the bracket


sorry i'm lost! where in the bracket? which bracket? can you post a picture of said bolt in said bracket?? ??? ??? ???
Logged

Offline Gambit

  • Forum addict
  • *
  • Posts: 4,354
Re:Door Adjustment
« Reply #8 on: 11 December 2003, 10:25 »
no pics sorry.

open your door wide, you will see two brackets/hinges holding the door onto the body

put(hold) the wheel stud in bottom bracket so that when you close the door over the wheel stud is trapped in the bracket, and gently tug the door. open the door remove the wheel stud then test to see how much it has lifted

repeat until u get it perfect

like this

/*\

/\ = door hinge
* = wheel stud

« Last Edit: 11 December 2003, 10:29 by Gambit »
Logged

Offline troublesome51

  • Just got here
  • *
  • Posts: 5
Re: Door Adjustment
« Reply #9 on: 22 November 2005, 14:16 »
i know this is ages after its been posted, but i need o do this fix on my drivers door as its dropped slightly.

Can someone give me a bit more detail i dont understand whre to put the wheel stud (oh and what is a wheel stud)

cheers guys

Just realised MK1 ive got an MK4, is it the same??
Logged
Pages: [1] 2
« previous next »