« previous next »
Pages: [1]

Author Topic: how to fit a gear gaitor  (Read 1190 times)

Offline mboon

  • GTI forum regular
  • ***
  • Posts: 217
how to fit a gear gaitor
« on: 13 July 2010, 08:43 »
as above. How do you remove the plastic bit that holds it on

is the gear knob screw fit. Any tips and hints
Logged
Part of the GTi 16v Flying Squad and the Special Forces //M Department

Offline dragonfly

  • I live here
  • *****
  • Posts: 1,111
Re: how to fit a gear gaitor
« Reply #1 on: 13 July 2010, 08:50 »
Yes the gearknob is screw fit. Once removed either slide the gaitor over the shaft or break the plastic collar. You can secure the new gaitor with a small zip tie at the top.
Logged

Offline mboon

  • GTI forum regular
  • ***
  • Posts: 217
Re: how to fit a gear gaitor
« Reply #2 on: 13 July 2010, 15:05 »
Sorted, cheers
Logged
Part of the GTi 16v Flying Squad and the Special Forces //M Department

Offline russ-vdub

  • I live here
  • *****
  • Posts: 1,350
  • Once a Dub, Always a Dub
Re: how to fit a gear gaitor
« Reply #3 on: 14 July 2010, 15:45 »
^^ You need a Haynes ;)
Logged

Offline Thom89

  • Forum addict
  • *
  • Posts: 4,096
  • Looking for an "Icebreaker"
Re: how to fit a gear gaitor
« Reply #4 on: 16 July 2010, 13:55 »
To do the job correctly, turn gaiter fully inside out, place over gear lever upside down, fasten cable tie around lever shaft, then pull gaiter down to secure the base, this way the cable tie is fully hidden, and looks OE, as opposed to gash :wink:
Thom
Logged
Pages: [1]
« previous next »