Had my ED30 on Awesome rollers today...

[neg]

Nice power figures, what settings are you running?

[markymark]

Nice power figures, what settings are you running?

My mate does a lot of maps for various tuning houses and has said he will do mine for nothing. He used to work for AmD and other big names, im very tempted by this now. His web site is www.dnatuning.com and what is even better is that he lives 2 minutes away from me!

[Vtec Abuser]

Nice power figures, what settings are you running?

Running Boost 8 Timing 5 mate.. I was told (even though I always use 99 ron) that timing 5 is about as high as I should go, as when the weather starts to warm up (eventually  ) it may start pinking if I go any higher. Will have a play about when I get my Select + switch in the next few weeks and see..

[SteveS]

you can adjust all that urself?

[Vtec Abuser]

Yes mate, son long as you have one of these..
http://www.revotechnik.com/products/sps.aspx

[SteveS]

looks very simple, one knob? do you program it on your pc or something :s

how much does that cost then!!!!

[Vtec Abuser]

Haven't used the new one yet, so not entirely sure mate. But the previous one had two knobs and was very easy to use.
They are normally £250 + the dreaded, but you can get them a lot cheaper 2nd hand..

[Vtec Abuser]

Awesome have finally put up our vids and graph from the other weekend if anyone's interested..
http://www.awesome-gti.co.uk/rollingroad/rr.scn_260408.html

Graph..

[neg]

Switch is easy to use, little bit better than the older versions as you can use the new one to read the values off the car - I always used to forget.

The main bits on the new one is setting A B & C, you can pre-set 3 different settings into the unit for fast switching or connect up through a laptop (USB) and alter your settings that way.

I run 6/6/9 on an everyday basis (Non Ed30 mind), when playing with the settings its always best to do some logging to make sure the CF values are not too high.

[Kiddfrost]

Switch is easy to use, little bit better than the older versions as you can use the new one to read the values off the car - I always used to forget.

Mine's a non ed30 too, can you "aquire" your settings from the ecu? I've tried and can't do it with my sps+. I contacted Revo and they said sps+ will only aquire the settings from certain ecu's