hmm will the look be ok?

[Wayne]

I think they are 46's if I remember what my cousin said. They're not the same as the ET20 most of the reps are.

Doubt they are et46 as that is fwd offset, I guess they will be 26.

[pinson]

Cheers, will have a ganders

Offset will be way too low for them to fit and work all ok.

what offset should i be looking for?

[stainesy]

For 17's I'd say a total offset of ET25 front and ET20 rear max if you plan on tucking them and rolling your arches. But remember the adaptors to fit them will be probly 20mm so if they are ET26 with the adaptors they will end up ET06

[Wayne]

For 17's I'd say a total offset of ET25 front and ET20 rear max if you plan on tucking them and rolling your arches.

That is tight for 17", I ran et35 and had clearance issues.

[stainesy]

For 17's I'd say a total offset of ET25 front and ET20 rear max if you plan on tucking them and rolling your arches.

That is tight for 17", I ran et35 and had clearance issues.

really? even with rolled arches? spose it all depends on the ride hight really.
basicly they aint gona fit right mate. 

[pinson]

For 17's I'd say a total offset of ET25 front and ET20 rear max if you plan on tucking them and rolling your arches.

That is tight for 17", I ran et35 and had clearance issues.

really? even with rolled arches? spose it all depends on the ride hight really.
basicly they aint gona fit right mate. 

Thanks for the advice, I'm still relatively new to all this so dont really understand lol

I got quite excited when I looked at the link for ebay as I thought it said Chester but then realised it was Chester le Street in Durham.