« previous next »
Pages: [1]

Author Topic: Powder coated carriers  (Read 787 times)

Offline Hector-8

  • Not said much yet
  • **
  • Posts: 67
Powder coated carriers
« on: 26 March 2012, 21:33 »
Okay got my carriers back from powder coaters and tried to fit the slides. They wont fit as some powder coating may have got in the holes. I have had a look at the slides and they all appear to be thinner on the bottom and gradually thicker towards the top. I have all four slides cleaned up and notice that they are not are the same looking. 2 are squared off and 2 are ringed...

My question is, can I drill the holes out until they slide freely or does this ruin the carrier?? The two smaller (ringed type) slide freely the other two are tight.

Logged

Offline Mr Blue

  • Forum addict
  • *
  • Posts: 6,133
Re: Powder coated carriers
« Reply #1 on: 26 March 2012, 21:48 »
small drill bit and shake it around. See what happens  :evil:
Logged
:)

Offline Hector-8

  • Not said much yet
  • **
  • Posts: 67
Re: Powder coated carriers
« Reply #2 on: 26 March 2012, 23:00 »
Just didnt know whether the insides of the carriers are shaped to fit the slides. If not, I shall be doing some shaking tomorrow.  :laugh:
Logged

Offline danny_p

  • Forum addict
  • *
  • Posts: 4,646
Re: Powder coated carriers
« Reply #3 on: 26 March 2012, 23:13 »
grind to powdercoating off on the mounting faces as well,   i've known it allow the carriers to work loose before
Logged
all the VW's have gone bar 1.
Pages: [1]
« previous next »