VR6 WARM START ISSUE CUTS OUT

[todd]

Sounds like a crank sensor because it's not starting when hot will be on the front of the engine next to the gearbox bell housing

[francoisd2446]

Changed the hall sender also still now joy, guessing by the sound of it the injector and fueling are out, either injector is gone or pump is gone......

BTW if disconnect battery for 30 mins will this just reset everything I guess.....running out of ideas now and patience...

[francoisd2446]

Here is the noise I get from injectors...  http://youtu.be/h81ZziGgpOs

It sounds like air but could it be stuck open injector causing flooding and non start ?

[francoisd2446]

Ok plan of attack;

1) Going to try the "dumb mode" on vag software to see if get coms
2) Going to pull out injectors prime and see what is going on
3) Going to test ohms on injectors using multimeter
4) Going to get to crank angle sensor and possibly replace
5)clean up throttle body
6) look to change the brown sensor on in thermostat housuing.

[francoisd2446]

Ok looked at earths today fixed a couple of doggy ones, so did not get to check fuel injectors, again starts first time then refuses to start, vag com in dumb mode only finding abs,,,,,

??   

[DubAndDubber]

HAVE YOU CHANGED THE CRANK SENSOR YET!

[francoisd2446]

I will change the crank sensor but want to find out what that noise is coming from the injector......

[todd]

Fit the crank sensor get it running then replace injector if necessary, or if your really worried do it the opposite way round. Simple

[francoisd2446]

Thanks for all the comments just ordered new crank sensor.....keep you updated...

[DubAndDubber]

How many times have you cranked it over? It could be possible that youve knackered your ECU.