about to fit coilovers leveling???

[dubpirate]

right i bought a jom kit for 180 guys cheep cheep whatever

i want is on its lowest setting

so can i just have the c spanner rings off the thread front and back

and if i did it like this would it sit level??

cheers dan

[dom]

right i bought a jom kit for 180 guys cheep cheep whatever

i want is on its lowest setting

so can i just have the c spanner rings off the thread front and back

and if i did it like this would it sit level??

cheers dan

It would sit level in terms of n/s being the same height as o/s but the rear may end up lower than the front

[stainesy]

as above the diferance between front and back would be alot i recon. my car sits level all round but my fronts are near bottom of thread but i got quite abit of thread left on the rears before it gets to bottom.
i take it you are running 15" wheels?

[Wayne]

No need to remove the rings, let it settle 1st then lower it some more.

[dubpirate]

13 steels atm but bidding on sum bmw e30 bbs 15s

[DubAndDubber]

i think wayne will be about to tell you you'll need arch work to fit those!

[Wayne]

i think wayne will be about to tell you you'll need arch work to fit those!

Depends on offset most Bmw wheels are low offset so will / may need arch mods.

[Len]

Always best to set them, then drive it around, especially roundabouts to see if there are any scrubbing issues then reset.