how do I change the green LED for the rear fog on light switch?

[jbg]

The green LED for my rear fog on the headlight switch doesn't illuminate.
The rear fog light works, as do the front fog lights and with it's green LED.

I've taken the switch out ok but cannot see how to strip it in order access the LED that's gone.
Can anyone advise preferably with photos as I'm very nervous of snapping/damaging bits of plastic tabs etc.

[Wazzzer]

Just buy another one, loads less hassle and you might cock it up and have to buy another one antway

[jbg]

Just buy another one, loads less hassle and you might cock it up and have to buy another one antway

seems a shame if it just needs an LED . Someone must have taken one apart and know if it can be done reasonably easily.

[richw911]

Just buy another one, loads less hassle and you might cock it up and have to buy another one antway

+1

[jbg]

Just buy another one, loads less hassle and you might cock it up and have to buy another one antway

+1

in case anyone else reading this rushes out and buys a new switch based on this advice.
I've since found out that on pulling out to the second notch (rear fog) the symbol is not meant to go green. Instead, The rear fog being on is indicated by an orange light on the dash

[richw911]

Read the manual before posting 

[jbg]

Read the manual before posting 

back at ya 

[richw911]

Read the manual before posting 

back at ya 

  

I never use the fogs TBH and though it was a green light 

[Wazzzer]

you were asking how to repair the LED in the switch, I was telling you it would be easier to fit a new one. Not my problem if you don't know how the fog light switch illuminates

[jamie16v]

handbag fight