Rear axle bush removal method + Bush type confirmation.

[Big Tone]

Could hydraulic pullers be used to "press" the bush out?

Trying to get everything ready to do the job.

Need an eazi bleed and some brake fluid also.

And VRS bushes from the hundereds of other threads yes?

[bullzeye]

  awww could have been another job i had for you lol mines in the garage at the moment getting them replaced £100  and an all day job the recon hummm

[Wazzzer]

air chisel, blowtorch, hammer, crowbar, anything sharp, hacksaw etc to get those bloody things out

[RTechUK]

air chisel, blowtorch, hammer, crowbar, anything sharp, hacksaw etc to get those bloody things out

+1 brute force and blood 

[tech1889]

blowtorch will be the easiest way... just heat them up proper and then they should easily come out 

[Big Tone]

Nice
Think il hit coilies, bushes and top mounts all at once!

[Wazzzer]

blow torch will melt the rubber but you'll need to cut the shells with a hacksaw to get them out afterwards

All I can say is... good luck

[godsANGER]

All I can say is... good luck

ill second that lol

[Big Tone]

  awww could have been another job i had for you lol mines in the garage at the moment getting them replaced £100  and an all day job the recon hummm

think the list is long enough bud! 

[marcford86]

I didnt find them too bad to do when I replaced mine, although I was on a 2 poster ramp, apart from usual tools to take everything off, to get the bush out I used threaded bar and 2 large sockets as a puller to get the old bushes in and out, had to chisel one outer casing out but wasn't really a struggle. Going to do them again soon and replace with polybushes