« previous next »
Pages: [1]

Author Topic: HELP!! Boost gauge fitting...  (Read 782 times)

Offline G0LF_GT1_TURB0

  • Not said much yet
  • **
  • Posts: 45
HELP!! Boost gauge fitting...
« on: 23 May 2011, 18:18 »
 :angry:

been outside for the last hour trying to find a way into my cabin via the engine bay.. without any luck! this is the second time iv been out.. stripped the drivers foot well and plastic panels from around the fuse board but still cant see a way through?

seen one link on here that describes a gromit above the accelerator pedal but i cant find this... and cant find any other possible way through?

if anyone has any pictures to show me where to go through please post them as this is sending me mental! iv had the boost gauge for over a week now and still not been able to get it installed!  :undecided:

any info would be great!
Logged
2001 1.8T AUM, k03s, silicone TIP, forge 007p, cold air induction kit, milltek exhaust, 4motion rear valance.. and more to come :)

Offline daz veedub

  • Forum addict
  • *
  • Posts: 5,534
  • Operation 1.8t bolf
Re: HELP!! Boost gauge fitting...
« Reply #1 on: 23 May 2011, 18:36 »
i went through the bonnet cable gromit  :wink:
Logged

Offline Dave_IOW

  • Forum addict
  • *
  • Posts: 4,677
Re: HELP!! Boost gauge fitting...
« Reply #2 on: 23 May 2011, 18:43 »
as you are looking from front of car into engine bay, right hand side, half way down, there is a grommet. This comes out behind glovebox and you do not need to remove glovebox to get to it! Feed a coathanger through with vacuum hose FIRMLY attached!

:wink:
Logged
Project: Mk2 20vT trackslag
Daily: Mk2 GTI typ19

Offline symsymma

  • I live here
  • *****
  • Posts: 854
  • AGU POWER,drive it like u stole it!!!
Re: HELP!! Boost gauge fitting...
« Reply #3 on: 23 May 2011, 18:55 »
Quote from: Dave_IOW on 23 May 2011, 18:43
as you are looking from front of car into engine bay, right hand side, half way down, there is a grommet. This comes out behind glovebox and you do not need to remove glovebox to get to it! Feed a coathanger through with vacuum hose FIRMLY attached!

:wink:
+1 vac hose and power cable for amp go through there on mine. :wink:
Logged
1.8T AGU 203bhp & 233lb/ft Rtech stage 1 custom remap,18"dezentz rims,lowered 40mm shocks n springs,whiteline 24mm adj rear arb,lcr axle bushes,polybushed arb,modified front bumper & valences,depo projector headlights,delocked,wrapped interior&bora gear knob,forge boost & coolant hoses,forge tip,forge 007p,samco vac hoses,simota aeroform cai,saiko michi catch can,deleted pcv system,r32 dogbone,miltek lg bore down pipe & sports cat/non res anni style system.
Pages: [1]
« previous next »