Dan's N5T LO daily - VR6 Turbo build starting #95

[lemski]

Dan thats crazy. How u r ever going to mod this further i dont know. My mates ibiza not much higher than urs but he hasnt gone through one yet. Maybe he has raised his engine though. Any way car lucks good b4 driveshaft

[Dmonday]

Sorry for lack of replies, barely on the comp now

Anyway, raised the engine and got some 6n driveshafts off my mates polo and turns out the one i need is an inch too short




Both ends of the driveshaft went..






Dan

[Dmonday]

Bodged a 6n drive shaft to fit and work, going to pick up a proper ibiza drive shaft after work tomorrow and now i've raised the engine the driveshaft is knocking on the very corner of the notch, so going to take an angle grinder to that tomorrow night but for now... she's back on the road!

[dom]

....until next weekend when the next drive shaft is buggered

[Dmonday]

....until next weekend when the next drive shaft is buggered

hopefully not, raised engine i hope will prevent it.. just need to chop a little more of the chassis away

[Chris-White]

I dont get it 

[thai-wronghorse]

Raised engine means less angle and therefore stress on the suffering driveshafts.

[Chris-White]

Raised engine means less angle and therefore stress on the suffering driveshafts.

i meant the whole concept of this car in general. not the raising of the engine.

[Jack3559]

Raised engine means less angle and therefore stress on the suffering driveshafts.

i meant the whole concept of this car in general. not the raising of the engine.

I think it's only Dan that does!

[dazzawest1987]

What's not to get? Cheap daily run about slammed on it's arse