vagcom coding for audio / telephone... help please!

[mortygt140]

It wont fix it mate cos its not broke... the fan goes off about 20mins after you leave the car but once you unlock your car and get back in the unit will start back up even before your sat down,  its so it can start getting the navigation ready.

Don't worry about it mate its normal

Darren

[p3eps]

So I will NEVER see the startup screen again?!

[mortygt140]

You will see it if left over night and the unit is stone cold,

Darren

[p3asa]

Where is the smillie for banging your head off a brick wall!!!!     I've been telling you that p3eps for the last 5 hours 

[p3eps]

Where is the smillie for banging your head off a brick wall!!!!     I've been telling you that p3eps for the last 5 hours 

Fair cop!!   

[p3eps]

Just been out sitting in the car this morning - refitting my RNS510.

All went well... apart from I seem to have 'lost' my reverse cam.  I can't figure it out!
When I plug the RCD510 back in, the cam works, so I'm assuming its somewhere in the coding.  I also had it working with the RNS510 yesterday - so I don't know whats gone wrong.

Other than than, my steering buttons & MFD all work properly.

What exactly should I have checked for the Reverse Cam.  I've been through all of the options and think I've ticked them all... but it would be good to have a reference to check off against.

I seem to have a LOT of errors when I do a full scan though.

[SteveP]

To enable the reverse camera you need to: -

Open the Navigation (37) controller and select coding, then long coding helper, then in the forth block set bit 6 to on (shown as "Backup Camera Low"), close the long coding and saving the new coding. Reboot the RNS-510 by pressing the "<" & ">" & "i" button.

[p3eps]

Thanks Steve...

I will go double check after my dinner - but I have a funny feeling that ones already ticked.  Any more?

Also - how do I get the Dynaudio logo to appear on startup?

[SteveP]

Under long coding there is an option (as a drop down list) to set the type of speakers/soundpack you have (again in the 37 - Navigation controller). Dynaudio needs to be set here.

[p3eps]

Under long coding there is an option (as a drop down list) to set the type of speakers/soundpack you have (again in the 37 - Navigation controller). Dynaudio needs to be set here.

Is that the bits Darren posted in his link in the first page of this thread?

I'll go try them now and let you know how I get on!