air intake system question

[navmk4gti]

you had any probs with it ivor?

The Pipercross???  i had it on for about a week, lol!!  Too much puddle-paranoia!!! 

  hopefully you wont have any probs then... personally im too scared to take that risk putting filter that low.. to much crappy weather:sad:

Shouldn't have, seeing as I've now got the ebay jobbie on these days! 

wise 

[Dalo Harkin]

I have the one that sits in the inner wheel arch, I dont think that the cone would get soaked in water to a degree that it makes it all the way up the pipe mate - I'll get a pic at weekend and post it for you

[Rhyso]

I have the one that sits in the inner wheel arch, I dont think that the cone would get soaked in water to a degree that it makes it all the way up the pipe mate - I'll get a pic at weekend and post it for you

here's a reminder of what damage water can do to your engine 

OUCH!!

[topher]

i'll have to get a picture of leigh's bent rod.. its a corker - caused by one of those kit's, a large puddle, and his missus' carelessness

[navmk4gti]

I have the one that sits in the inner wheel arch, I dont think that the cone would get soaked in water to a degree that it makes it all the way up the pipe mate - I'll get a pic at weekend and post it for you

here's a reminder of what damage water can do to your engine 

OUCH!!

i dont see y people bother taking the risk ... i think i might stick to my ebay job

[Rhyso]

I have the one that sits in the inner wheel arch, I dont think that the cone would get soaked in water to a degree that it makes it all the way up the pipe mate - I'll get a pic at weekend and post it for you

here's a reminder of what damage water can do to your engine 

OUCH!!

i dont see y people bother taking the risk ... i think i might stick to my ebay job

i don't either especially as the conclusion from many a dyno run suggests that a decent panel filter gives about the same results but without the fear of destroying your engine!!

[T_J_G]

I have the one that sits in the inner wheel arch, I dont think that the cone would get soaked in water to a degree that it makes it all the way up the pipe mate - I'll get a pic at weekend and post it for you

that's the one Ash had...

[Dalo Harkin]

I prefer the roar that the induction kit gives - but if it can knacker the engine - time to break out the angle grinder again 

Seriously though - I dont think that water could travel up the amount of space and the bend in any great quantity - its not an inverted snorkel at the end of the day lmao

[T_J_G]

As I said ash had that kit and that soaked up water and knackered his engine

[Dalo Harkin]

Aluminium induction kit for sale.........

and advice on what needed to replace it with.........and not a panel filter if possible, I like the noise of some induction