DIY Wheel Repair

[Tornado]

Hello
I have just acquired some alloys ( ebay unfortunately) and the wheels while generally ok have scratches round the edges.
I would like to repair these myself, has anyone done this before?
I thought I might start with a dremel then do some wet and dry then polish but any good tips would be useful.
Ta
Alan

[Tornado]

Hello again

 :sad:Has nobody tried this then or is it just a sh!t idea?
Regards
Alan

[Uruk Hai]

I just finished sanding down 4 BBS RA's by hand and I'm never ever doing it again (I have no finger prints left  ), having said that I am very happy with the results and all I used was a few scotch pads some 240 grade sanding disc's and a small file for going around the edge of the rim to smooth out the rough bits and kerb scrapes. There were a few dents and for that I mixed up a tiny bit of filler and put as little as I could in the dent and then flatted it back with the rest of the wheel, there were a few bits of quite heavy corrosion so on those bits I used a dremel with a steel carbide wire brush and ground it back to the bare alloy. After rubbing the wheel down I etched primed it and this shows up any uneven bits or heavy sanding marks so I can go over those bits with 4 or 6 hundred wet and dry, when I've done this to all 4 wheels they'll be painted, thank god 

[Judderi]

Its certainly is allot of work!

[rowlers]

I too have just refurbed a set of ATS Cups, and will repeat what Uruk said, no finger prints left, absolutely knackering, and would deffo not do it again. Having said that I got a set of nice looking rims for £70, and am please with the results.

Take them to a specialist and pay the £40 per wheel!

[Uruk Hai]

Amen to that dude 

[Len]

I'm about half way through doing a set of Momo's. I started off using a metal file, then a good Isopon metal filler then good grit paper.

Just gotta get the paint matched.