Hey folks,
I fitted the mic for the bluetooth unit today, followed the guide but now just realized, there is one part that actually goes OVER the airbags, which I guess is not ideal at all.
If you imagine, you run the wiring from the map light area, across to the grab handle area and then down the outside of the a-pillar (just tucked the wire inside the black flexible rubber seal) the airbag in the A-Pillar is being avoided as the wire is on the outside of it, however, at the top of the A-pillar, where the wire comes from the grab handle, to actually get it to the outside of the A-pillar it goes across the top curtain airbag at the top of the driver side door.
Now, I can think of 2 possible solutions here, if anyone could advise that would be great;
1) Instead of going outside the A-pillar, take off the Pillar and run the cable down the inside - this to me, would be worse as the airbag would potentially be blocked off like that.
2) I will check tomorrow to see if there is a gap between the airbag at the top of the A-Pillar ,and the top curtain airbag, if so, will put the wire through that gap - this seems the best option, but pretty sure there was not a gap when I looked earlier.
Or it could be that the way I have done it is fine, but can't help but feel having a wire across the airbag is not the greatest idea should they ever go off.