Drive Shaft popped out (SORTED) :)

[pickles]

Got a strap wrench or a pair of stilsons to hold on to the shaft?

i think the shafts disconnected from the assembly so i dont think thatl do any good m8, the full inner joint is rotating, thinkin i might need to cut into thoe put to try and counterhold it somehow.

popping to halfords just shortly for the spline set tho, see what else they might have

[Steve_PD]

Stick the gear box in reverse should stop it from rotating.

[pickles]

Stick the gear box in reverse should stop it from rotating.

thanks again m8, if we ever meet il buy you loads off pints 

[pickles]

found out the clip was still attached but the bearings had came off the roller.


Managed to chap em back on with a mash



axle reinstalled along with circlip, just need to grease up, reassemmble n put back on, Happy Days


had to use a puller to remove the assembly from the splined shaft, other than that, very simple job id say

[pickles]

any1 ever used Comma Multi Purpose Grease on CV joints before, only stuff iv got