GolfGTIforum.co.uk
Model specific boards => Golf mk6 => Topic started by: SunnyGTI on 23 May 2015, 21:11
-
Hi
Has anyone fitted a reversing camera (genuine badge or aftermarket) themselves? The trickiest thing for me is how to do the wiring from the camera to the stereo... :/
I am guessing it goes under carpet, through the middle but does anyone know a better way or some tips please?
Thanks
-
I'm having mine professionally fitted on Friday so I'll let you know!
-
Theres a couple of retrofit guides on the American forum.
Heres one I quickly found
http://www.golfmk6.com/forums/showthread.php?t=20119
-
I installed mine, the cable runs up the sill on the drivers side.
You just need to remove the plastic sill cover, and some more around the rear hatch, been a while since I did mine.
Snoopy's link looks like a good place to start. :smiley:
-
Thanks all!
Mike- did you fit the Badge camera or a different one?
-
It was the badge camera.
SteveP, on here, used to sell the kit but I haven't seen him about for a while
-
If SteveP isnt doing them anymore (i have used him a few times for upgrades and would recomend him) I have also used http://www.carsystems.pl/ a few times and had good service from them. Ive been meening to get the camera from them myself for a while.
http://www.carsystems.pl/vw-rear-emblem-camera-kit-retrofit-golf-6,id233.html
I have had a quick look and this is the bookmark I have saved but Mike will know better if thats the correct one?
-
Thanks guys. I have gone for an aftermarket camera that goes near the number plate as its a lot cheaper and easier to set up that the badge camera :)
The flip out badge camera is very cool though!
-
How did you get on with this any update?
-
How did you get on with this any update?
Fitted a reverse camera near the number plate light. Took a lot of time to figure out how to get the wire from inside the boot to the outside but managed it without drilling holes. There is a gromit thingy on right hand side of boot and got wire out through there and near the bumper. Then just a case of using a coat hanger through the number plate light to fish out the wire and pull it through.
A lot of effort but worth it for a reversing camera that didn't cost too much ;)