Little update for today.
Down the morning cleaning the inside of the car hovering and then rubbing with thinners ten Hoovering he bit I had out haha
Then went round with the liner and touch up any bit that's needed doing.
I then took the rear coilovers off of the daily and Pu standard suspension back on as I want the weitecs for the project.
While doing this I got a nice little delivery
Front and rear wheel bearings
I then spent a good while doing some painting.
Did the whole front end including the footwells and roof and also did the side panals and part of the roof at the rear.
I stopped there as I still need to weld in the harness bar that shall hopefully be arriving soon!
I also removed and painted the set mounts while I was at it
A few pictures
I also got around I fitting the front wheel bearing that had arrived and painted up the hub
I also had a massive tidy up in the garage an around the car as it was a little bit of a mess....
Going to be busy at work now for a few days but hopefully I will e able to squeeze in gettin the harness bar started when it arrives
But progress is good at the minute all I need to do it do the harness bar then put the tank, rear beam and exhaust on and then change all the front suspension over including subframe, hubs, wishbones, steering rack and coilovers and ten it's ready to go on the road with the standard engine.
And then the engine rebuild will start