« previous next »
Pages: [1]

Author Topic: Bonnet release catch?!  (Read 1249 times)

Offline scarr89

  • I live here
  • *****
  • Posts: 3,223
  • Mk4 Golf, DERV FTW!
Bonnet release catch?!
« on: 02 April 2014, 17:29 »
I removed my bonnet release catch as I had the front slam panel off the other day. Have put it back on, in the same 'reverse' order as any good Haynes manual will tell you...But now it does not 'lock'.

You get the stage where you give the bonnet a shove to give it the final lock and it doesn't. It sits higher than the wings, in the 'stage 1' of the '2 stage' locking process.

It is well oiled/cleaned...Cannot figure it out  :huh:

Anyone?

Cheers
Logged

Offline Dalo Harkin

  • I live here
  • *****
  • Posts: 2,070
Re: Bonnet release catch?!
« Reply #1 on: 02 April 2014, 17:40 »
when I took mine off it was literally a millimetre out on one side to where it should be - repositioned it and it was all good
Logged
ARZ K03s, Oettinger Side Skirts, R32 front, Carbon stage 2, Forge 007p (yellow spring), Forge Actuator (yellow spring), Pipercross panel filter with DSG parts, N249 and N112 deleted, SAI deleted, Carbon canister deleted, Rear wiper deleted, Long Life turbo back custom exhaust with 200 cell sports cat, VR6/G60 clutch kit, Creation Motorsport TIP, Catch can, 'Wellycooler', K04 charge pipe, S3 ported inlet manifold - looks pretty standard on the outside though :)

Offline Wazzzer

  • Moderator
  • 10k hero
  • *****
  • Posts: 11,172
  • Golf GTI 1.8T AGU
Re: Bonnet release catch?!
« Reply #2 on: 02 April 2014, 19:18 »
the holes are elongated so it's adjustable , probably just a case of getting in the right position again
Logged


1999 1.8T: R-Tech remap - 225bhp/256lb/ft : K03s : THS FMIC : THS PCR pipe : 2.5" stainless exhaust : THS FR3 Engine mounts : G60/VR6 clutch : Calibra Yellow injectors : VR6 MAF : Devils Own WMI : Forge 007p : Carbonio CAI : Leon Cupra R Brembos : FK AK Street coilovers : Votex skirts : Anniversary front : click ---> http://www.golfgtiforum.co.uk/index.php?topic=92175

Offline scarr89

  • I live here
  • *****
  • Posts: 3,223
  • Mk4 Golf, DERV FTW!
Re: Bonnet release catch?!
« Reply #3 on: 02 April 2014, 20:28 »
Quote from: Wazzzer on 02 April 2014, 19:18
the holes are elongated so it's adjustable , probably just a case of getting in the right position again
Quote from: Dalo Harkin on 02 April 2014, 17:40
when I took mine off it was literally a millimetre out on one side to where it should be - repositioned it and it was all good

Both spot on.

I had a little play, it was probably 2mm out.

Cheers
Logged
Pages: [1]
« previous next »