Vinyl roof... Pics, not asking advice.

[Jimmy Filth]

So, just spent the afternoon doing my roof with the help of a mate.  It was a first ever attempt with this stuff but I'm quite happy how it has come out.  It has creased in one particular corner, but my mate is making me a design in shiny black that will cover that corner (if it looks good that is). Haha.

It took a fair few hours and a lot of lifting and relaying it.  It's actually had to be done in two parts as I may have torn a small section of it, but you can't see the seam so it looks good enough.  A pro would have done it better no doubt, but I want to do all the work on this car myself.

[HeavySmoker]

sex..

do the same to the bonnet now  will look bad

[Jimmy Filth]

I've just done the mirrors while laying on my bed.  Is it wrong I'm taking car parts to bed?? Hahaha

[HeavySmoker]

I've just done the mirrors while laying on my bed.  Is it wrong I'm taking car parts to bed?? Hahaha

quite normal

[shepgti]

would have been easier to spray it, even with rattle cans then you wouldnt have the creases down the edge?

[snifferdog]

Looks good! I want mine doing.

[Jimmy Filth]

would have been easier to spray it, even with rattle cans then you wouldnt have the creases down the edge?

This way if I get bored of it I can just peel it off and not have to worry about it, plus this was considerable less work and probably cheaper, it cost £60 for the vinyl and that came with a free tool to smooth it.  The creases were purely down to my inexperience, plus I don't think I used enough heat.

[snifferdog]

Whats with the sticker though? That is my only dislike.

[Jimmy Filth]

It's a company called Carhartt.  In fact, I think most of my clothes are by them, and unfortunate coincidence.  I'm just a fan of stickers, you should see my rear drivers side window. Haha

[shepgti]

would have been easier to spray it, even with rattle cans then you wouldnt have the creases down the edge?

This way if I get bored of it I can just peel it off and not have to worry about it, plus this was considerable less work and probably cheaper, it cost £60 for the vinyl and that came with a free tool to smooth it.  The creases were purely down to my inexperience, plus I don't think I used enough heat.

60 quid!!! rattle cans wouldnt have cost half that