Author Topic: jetta water pressure  (Read 1229 times)

Offline captin_urbis

  • Not said much yet
  • **
  • Posts: 49
jetta water pressure
« on: 27 December 2010, 10:50 »
good day,

i have done the mod for the mk3 parts and now my jettas building up too much pressure in the water system. i spent a fair bit bleeding te system and it was fine for a few days. but now, theres so much pressure water doesnt seem to be circulating round as my heater got warm very briefy and went cold.

am i right in thinking water pump is faulty?

cheers in advance, paul

Offline ramps

  • Not said much yet
  • **
  • Posts: 85
Re: jetta water pressure
« Reply #1 on: 27 December 2010, 11:06 »
from cold take the cap off the expansion tank, then start the car up and rev it a little bit and you should see water splashing round when you look into the top of the tank. If you cant see any movement then its time for a new pump plus backwashing the system to make sure there is no sh!te lodged anywhere

Offline captin_urbis

  • Not said much yet
  • **
  • Posts: 49
Re: jetta water pressure
« Reply #2 on: 27 December 2010, 11:35 »
backwashing?? but thanks will check once i get moving.

Offline 01664gti

  • I live here
  • *****
  • Posts: 1,252
  • mk3 hatch mk3 wagon and mk2 16v
Re: jetta water pressure
« Reply #3 on: 27 December 2010, 11:54 »
I spent days bleeding the air out of mine.They are always a pain

Offline captin_urbis

  • Not said much yet
  • **
  • Posts: 49
Re: jetta water pressure
« Reply #4 on: 27 December 2010, 22:27 »
yeah i have done. always seemed to be fine, but i beleive i have come across the problem.

the pressure was coming very quickly very hot. took a sniff of the water and i could smell exhaust gas. (engine was running while i tried to bleed the system) is there anyway i can test my predictions?

i think it may have been caused from the cold tempratures (there was no anti freeze) and i think i may have cracked one of the cyls. possibility i think is a high.

anyone got any pointers??

Offline rubjonny

  • 10k hero
  • *
  • Posts: 16,349
  • Hello, my name is John and I'm a dub addict.
Re: jetta water pressure
« Reply #5 on: 29 December 2010, 10:33 »
compression test should point out hg fail, alternatively remove all the spark plugs and shine a torch into all 4 cylinders.  usually if you have a water leak into one of the cylinder you'll see that piston is all lovely and clean. also sometimes if left overnight you'll have a puddle of water sat on top of the piston
Hello my name is John and I'm a dub addict.