Hope you guys can help:
I've had the engine light on my mk5 TDi 140bhp for a while now. Had the EGR valve replaced about a month or two back but it still lacks tht kick. The guy that replaced it told me that hte engine light wouldn't go off as I now need a new throttle body. Is what he said true judging by the below log?
-------------------------------------------------------------------------------
Address 01: Engine Labels: 03G-906-016-BKD.lbl
Part No SW: 03G 906 016 FM HW: 028 101 190 3 begin_of_the_skype_highlighting 028 101 190 3 end_of_the_skype_highlighting
Component: R4 2,0L EDC 0000SG 6179
Revision: 12345678 Serial number: VWZ7Z0D1261505
Coding: 0000072
Shop #: WSC 66565 257 00032
4 Faults Found:
19558 - Motor for Intake Manifold Flap (V157): No Signal
P3102 - 000 - -
Freeze Frame:
RPM: 0 /min
Torque: 0.0 Nm
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 12.31 V
Bin. Bits: 00000100
Torque: 0.0 Nm
Torque: 354.0 Nm
19557 - Motor for Intake Manifold Flap (V157): Open or Short to Ground
P3101 - 000 - -
Freeze Frame:
RPM: 0 /min
Torque: 0.0 Nm
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 12.31 V
Bin. Bits: 00000100
Torque: 0.0 Nm
Torque: 354.0 Nm
17075 - Fan 1 Control Circuit: Short to GND
P0691 - 000 - -
Freeze Frame:
RPM: 0 /min
Torque: 0.0 Nm
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 12.31 V
Bin. Bits: 00000100
Temperature: 81.9°C
Duty Cycle: 9.6 %
16618 - Boost Pressure Regulation: Limit Exceeded (Overboost Condition)
P0234 - 000 - -
Freeze Frame:
RPM: 2268 /min
Torque: 148.0 Nm
Speed: 119.0 km/h
Load: 32.2 %
Voltage: 13.98 V
Bin. Bits: 11000000
Absolute Pres.: 1744.2 mbar
Absolute Pres.: 2193.0 mbar
Readiness: 1 2 0 0 0
My EGR valve was replaced about a month or so back.....is that showing at fault?
The fault code I was receiving prior to the replacement of the EGR valve was:
19559 motor for intake manifold flap v157 malfunction P3103
