« previous next »
Pages: [1]

Author Topic: Wheel bore adaptors?  (Read 1109 times)

Offline kicklikeamule

  • Not said much yet
  • **
  • Posts: 55
Wheel bore adaptors?
« on: 06 October 2009, 09:28 »
Is it possible to get adaptors to change the bore width of alloys? Just wondering if it was possible to fit 5x100 alloys with bore 54.1mm onto the Mk3 with bore 57.1mm. And any alternative to having the centre bore widened by 3mm on the alloys themselves.
Logged

Offline Horney

  • 10k hero
  • *
  • Posts: 10,782
  • Racing, Trackdays, Starwars.
Re: Wheel bore adaptors?
« Reply #1 on: 06 October 2009, 09:36 »
You need to get them machined out or run a spacer that covers the centre lip.

Nick
Logged

Offline Wayne

  • Sir Postalot
  • *
  • Posts: 32,051
Re: Wheel bore adaptors?
« Reply #2 on: 06 October 2009, 09:38 »
You would better to get them machined, I am guessing they are Scooby wheels in which case you may also need the bolt holes sorting as they use studs with nuts and will be too small for your bolts.
Logged

Offline Len

  • 10k hero
  • *
  • Posts: 16,298
  • Guardian of the Seas, Protector of Waves
Re: Wheel bore adaptors?
« Reply #3 on: 06 October 2009, 13:20 »
Quote from: Wayne on 06 October 2009, 09:38
You would better to get them machined, I am guessing they are Scooby wheels in which case you may also need the bolt holes sorting as they use studs with nuts and will be too small for your bolts.

I concur!

Plus spacers if they are the scooby offset!
Logged
Mystic Blue Mk3 16v + Black Mk5 Gti 05 plate + Peugeot 405 Mi16

www.sas.org.uk
www.the-ace.org.uk
Pages: [1]
« previous next »