More help - New problem now!!

[bobbarley]

I'll have to keep an eye on them.  If they come lose again I'll be getting a new hub I guess, and bolts.

[richw911]

I'll have to keep an eye on them.  If they come lose again I'll be getting a new hub I guess, and bolts.

Or did some little chav try and undo them to steel them.... 

[dubcruiser]

Sounds like you might of over tightened them and stripped the threads... Close call but glad your ok Bob 

[Grand Master Patch]

Was it the drivers side?

[bobbarley]

Passenger side.  I was thinking the same, I remember one of the bolts going funny when I was tightening them, but that was the drivers side.

It wasn't someone stealing it, unless their intention was to only hald undo them all and replace the cap after.

[richw911]

It wasn't someone stealing it, unless their intention was to only hald undo them all and replace the cap after.

Ah yes forgot about the cap on the RC's

[bobbarley]

It wasn't someone stealing it, unless their intention was to only hald undo them all and replace the cap after.

Ah yes forgot about the cap on the RC's

Mate, that cap potentially saved my life!

[Steve_PD]

Very lucky Mr Bob 

Sounds like you might of over tightened them and stripped the threads... Close call but glad your ok Bob 

+1 if you were using a breaker bar then that sounds like a cause 
I'd take it steady tomorrow 

[bobbarley]

I never know how tight to do them, so always do it as tight as possible before they won't go any more.

[Steve_PD]

M14 = 110NM invest in a torque wrench