FREE FREE FREE!! Rolling Road session with print out.

[RTechUK]

Would an AGU be any use to you?

Bring it up, we still have your graph from the dynocom rolling road with the est wheel bhp, it would be nice to see how close we where with the calcs.  I think the Bosch rr will the a more realistic torque figure.

Nick

[danny_p]

ummm  you haz 4wd rolling road    the syncro may have to pay you a visit  at some point. 

may not fit but m8 needs to get his e46 on the rollers now ive reinforced the rear subframe.

if we unclip some trim it'll lift up to  110mm off the deck at lowest point and it's on 285/40/17's , dunno if you can work out wether it'll fit on from that but it is rather good at testing dynos       

[RTechUK]

ummm  you haz 4wd rolling road    the syncro may have to pay you a visit  at some point. 

may not fit but m8 needs to get his e46 on the rollers now ive reinforced the rear subframe.

if we unclip some trim it'll lift up to  110mm off the deck at lowest point and it's on 285/40/17's , dunno if you can work out wether it'll fit on from that but it is rather good at testing dynos       

Hello,

Its just our Bosch 2wd Front wheel drive rolling road we have been testing, the xspec dyno com 4wd road has already been commissioned.

[capoot]

Oww, Well wish i'd of spotted this eariler!!

[Paul86S2]

Are you still looking for people for this.

Mine is standard apart from one of your chips and an exhaust.

Paul

[MummRa]

Well having lerked here since getting my mk5 GTI about 6 months ago, this seems like a good time to make a post

I contacted R-Tech to offer my car (selfless I know), worked out well for me as I had just had some fairly significant repair work done and wanted to be sure all is working as intended.

Went over today as arranged and was very impressed, very friendly and helpful lot. Got a very positive result from the dyno run (196HP / 207Nm reported), and will defiantly be going back for a remap when I get round to it.

I hope those results where as helpful to R-tech as they where to me

[topher]

Nice to meet you today chap. Figures were spot on, that's 207 lbft not nm so right on the money! VW say 200ps which is 197 bhp and an impressively smooth graph. R-tech's rollers are even impressing skeptical old me.

[Jay]

Would a -80mm MK2 make it on the ramps? 

[topher]

we'll know tomorrow.. im enlisting this one for the day



if i buy the owner a mcdonalds he might let me play with the coilovers, then see if it fits on the dyno in between jobs. if there is any success he also wants a power graph as bribery

[Ben]

Here is the 2005 Mk5 GTi Stock Graph.



Nick