Author Topic: Creation Motorsport TIP and standard airbox  (Read 1605 times)

Offline Dalo Harkin

  • I live here
  • *****
  • Posts: 2,070
Creation Motorsport TIP and standard airbox
« on: 18 August 2014, 13:17 »
is anyone running a CM TIP and a standard airbox, mine seems to be too short, there is a bend about 4" before the MAF and obviously wont be good if left that way...
I think I am going to have to extend it slightly but that's just a PITA, any ideas? or has anyone else experienced this?
« Last Edit: 18 August 2014, 15:26 by Dalo Harkin »
ARZ K03s, Oettinger Side Skirts, R32 front, Carbon stage 2, Forge 007p (yellow spring), Forge Actuator (yellow spring), Pipercross panel filter with DSG parts, N249 and N112 deleted, SAI deleted, Carbon canister deleted, Rear wiper deleted, Long Life turbo back custom exhaust with 200 cell sports cat, VR6/G60 clutch kit, Creation Motorsport TIP, Catch can, 'Wellycooler', K04 charge pipe, S3 ported inlet manifold - looks pretty standard on the outside though :)

Offline jimmyGIT

  • Not said much yet
  • **
  • Posts: 64
Re: Creation Motorsport TIP and standard airbox
« Reply #1 on: 19 August 2014, 07:42 »
Morning,yes this is my setup.Mine was actually too long on turbo end so had to cut about inch off.Very snug fit but no other problems for me,very strange!. :undecided: all the best james.

Offline Dalo Harkin

  • I live here
  • *****
  • Posts: 2,070
Re: Creation Motorsport TIP and standard airbox
« Reply #2 on: 20 August 2014, 12:43 »
do you have a pic at all? I am going to have to chop mine anyway to extend it (sounds weird I know) but I will have to chop about 3" off then get a piece of ali and use the bit I cut off for between the ali pipe and MAF unless anyone has any other suggestions?
ARZ K03s, Oettinger Side Skirts, R32 front, Carbon stage 2, Forge 007p (yellow spring), Forge Actuator (yellow spring), Pipercross panel filter with DSG parts, N249 and N112 deleted, SAI deleted, Carbon canister deleted, Rear wiper deleted, Long Life turbo back custom exhaust with 200 cell sports cat, VR6/G60 clutch kit, Creation Motorsport TIP, Catch can, 'Wellycooler', K04 charge pipe, S3 ported inlet manifold - looks pretty standard on the outside though :)

Offline jimmyGIT

  • Not said much yet
  • **
  • Posts: 64
Re: Creation Motorsport TIP and standard airbox
« Reply #3 on: 21 August 2014, 07:54 »
Morning I never got round to sorting pics out on here but if you pm me your mobile number I will send you sum pictures of mine,not a problem.cheers james. :smiley: