GolfGTIforum.co.uk

Model specific boards => Golf mk3 => Topic started by: KingPin on 06 May 2008, 10:21

Title: Changing the crankshaft sensor
Post by: KingPin on 06 May 2008, 10:21

Hey Guys,

Anyone have any idea how to change the crankshaft sensor on a MK3 8v im told its not difficult just need guidance.

Thanks

Title: Re: Changing the crankshaft sensor
Post by: KingPin on 06 May 2008, 16:01

Just seen its also called the Crankshaft Angle Sensor or the Speed Sensor  :undecided:

cheers

Title: Re: Changing the crankshaft sensor
Post by: flex on 06 May 2008, 23:43

I only have experience with the 16v engine myself (i guess the 8v is similar) but when i changed mine it was in an awkward spot behind the oil filter. I had to remove the 2 big bolts that hold the starter motor/ front engine mount bracket in place, and also the big bolt holding the front mount itself to gain enough access to it. Once these were removed i dropped the engine down a bit while it was supported on a jack and i was able to undo the bolt that holds the sensor in, its just one bolt with a hex type head on it and it just slides out.

Peice of cake :D yeah.......

Title: Re: Changing the crankshaft sensor
Post by: KingPin on 08 May 2008, 14:32

Thanks bud.
8v is a smaller lump so someone has said to just take off the oil filter. Fingers crossed it works  :laugh:

Title: Re: Changing the crankshaft sensor
Post by: AndC on 08 May 2008, 14:44

Just done mine on my 8v, exactly as described by Flex was the only way I could do it!