GolfGTIforum.co.uk
Model specific boards => Golf mk3 => Topic started by: vdub virgin on 08 March 2008, 20:32
-
does any1 else hav problems with exhausts?
gt a standard exhaust on it n replaced the middle box 2 weeks ago n noticed there wasnt much room or much give in the exhaust around middle n back box,
but was fine............4 a week!
set off 1 day and middle box was knocking on floor pan n by end of day both the new clamps had loosened n it was blowing like f*ck! :angry:
had it tightened n re-aligned on weds n was fine until i booted it in second 2day n then i heard the dreaded knocking noise again!by the time i got home it was blowin!
this common problem with these exhausts?
gonna spot weld the clamps to stop em cummin lose nut surely u shouldnt hav to go to these lengths?
:cry:
-
i had the same problem... bit of exhaust gum sorted it out :wink:
-
where did ya have the exhasut fitted mate? being an exhaust fitter its rare that clamps come loose. one thing could be just a sh!t fitting exhaust and be slightly too big for the pipe so wont grip.
-
this problem can be caused by the small section after the cat,,,its just an extra piece of foot long pipe and if thats not fitted well the whole exhaust will be off! causing problems like yours!
I would check thats fitted fine first and adjust the exhaust there for better fit
-
il hav another go at it 2moro,bloody golfs!
gonna put lockin nuts on the clamps,thatl cap em! little buggers!lol! :smiley:
-
You need to use aero lock nuts not the normal nyloc ones as they will melt! There are lots of types on the market, have a good look around, try - www.bapp.co.uk
-
where did ya have the exhasut fitted mate? being an exhaust fitter its rare that clamps come loose. one thing could be just a sh!t fitting exhaust and be slightly too big for the pipe so wont grip.
when u re-do it everythings spot on n no knockin etc,bt as soon as you boot it its pulled outta place again!
could there be too much wear in the engine mounts so when you boot it the engines pulling on the exhaust?
-
You need to use aero lock nuts not the normal nyloc ones as they will melt! There are lots of types on the market, have a good look around, try - www.bapp.co.uk
cheers dude! :smiley:
-
Web sites off line at the mo for whatever reason, look some indusrial fittings places up in the thom local, bet theres one just round your corner!!!
-
stop being a gibbon and get a stainless system slapped on :D
-
:grin: :laugh:
its supposed to be a "runaround"!
im getting a bike!
although at this rate im gonna spend all my bike money on my golf! :rolleyes:
-
and whats wrong with that??
mines also a run around and allways needs money! (ok not allways need but it still gets too much £Â£Ã‚£Ã‚£ spending on it....)
-
cos otherwise im doin my bike test for no reason!lol!
n its nearly summer! yay! :smiley:
il be on a bike n in a tree in no time! :laugh:
-
have a look to see if there's any gunk coming out of the gearbox mount or excessive play in the front engine mount