GolfGTIforum.co.uk
Model specific boards => Golf mk3 => Topic started by: Diluxe on 15 December 2007, 19:20
-
Hi all,
could somebody please put up a shot or diagram of how the arb links attach to the wishbone on 16v?
cheers
-
like this?
(http://faculty.ccp.edu/faculty/dreed/Campingart/jettatech/polybushings/Dsc03363.jpg)
(http://faculty.ccp.edu/faculty/dreed/Campingart/jettatech/polybushings/Dsc03366.jpg)
-
cheers, but i think that mk2 4 stud rather than mk3 5 stud, the mk3 kind have attachment to link that kind of float out towards the wheel , but i need a picture of it.
ta :smiley:
-
no mate, thats def from a mk3 as its from a whole tear down of the lower section of the mk3 8v gti...i though they might be the same but obv not
-
this is what i was looking for
(http://i33.photobucket.com/albums/d96/diluxe/cvjoint.jpg)
what i cnat figure out is how the links manages to fit in between the end of teh ARB and connect to the wishbone without fouling against the drive shaft, like its currently happening for me know.
should the ARB be below the the wisbone or above, e.g links pointing up or down if anyone could take a quick pic or has a pic please post it.
cheers
edit: sussed it the wishbones on upside down :grin:
-
just buy the links from a motor factors for the gti -job done -
-
edit: sussed it the wishbones on upside down :grin:
:grin: