GolfGTIforum.co.uk

General => Cosmetic and bodywork matters => Topic started by: phil88 on 17 June 2007, 19:13

Title: Removing Front wing Mk2
Post by: phil88 on 17 June 2007, 19:13

whats the best way to remove the underseal that holds the wing to the car. have had a go before but failed. is there three bolts in the underdeal too? cheers, Phil

Title: Re: Removing Front wing Mk2
Post by: Mark_H on 17 June 2007, 19:17

Hi,

I removed mine from my Mk2 90 spec and it was OK. There are two bolts under the underseal.
I used a longish lever bar to remove mine. !!!!!! I've heard heating the undersealer up helps


Mark

Title: Re: Removing Front wing Mk2
Post by: mattneck(Beavis) on 17 June 2007, 21:11

bolts along the top, bolts below at the rear by the door, bolts below at the front end, bolt behind the grille bolt behind the bumper on the side, then you can open it up, chew out the sealer and undo the 2 in there.. simple  :cool:

btw mark cheers again for the wing, you had a look in my project?  :wink:

Title: Re: Removing Front wing Mk2
Post by: nealey on 17 June 2007, 21:25

I normally heat the wax up with a hot air gun or just set fire to it then get the screwdriver on it untill i find the bolt, the nsf wing always seems to be the most stubborn as well

Title: Re: Removing Front wing Mk2
Post by: phil88 on 18 June 2007, 22:48

cheers all for your help, took them off today. check my project page  :grin: