GolfGTIforum.co.uk

Model specific boards => Golf mk2 => Topic started by: dadrathers on 21 May 2007, 21:25

Title: Rusty jacking points
Post by: dadrathers on 21 May 2007, 21:25

Just forward of the front jacking point on the cills of my Mk II, there are two reinforced 'blobs' on the floor pan that are supposed to be used for trolley jacks and garage lifts. The one on the near side has rusted so badly around the 'blob' that it has torn away and pushed upwards. No good for jacking now!!

Has anybody else had this problem? - I am not aware that it is a common rust area on Mk II's. Any suggestions on what to do about it? Has it rusted from insde or outside? - I am planning to take it into the garage to have it welded up. It is about the only bit of serious rust on the car so need to get it sorted. Thanks.

Title: Re: Rusty jacking points
Post by: 8vRicey on 21 May 2007, 21:35

Yep!  :rolleyes:
Mine went on the O/S. Had to have it cut out and replaced for the MOT.  :shocked:

Title: Re: Rusty jacking points
Post by: ...joe on 21 May 2007, 22:01

yeah it is pretty common, tom26's did that and mine were a bit crusty in the same area but it was caught in time.

Title: Re: Rusty jacking points
Post by: dadrathers on 22 May 2007, 19:23

Thanks guys - it is somewhat reassuring not to be alone !!

Any idea whether it is rusting from inside out or outside in?

Nice car 8vRicey - mine's a black 5 door but with steel wheels (as yet) - your BBS look absolutely tops.

Title: Re: Rusty jacking points
Post by: 8vRicey on 22 May 2007, 20:04

^^ Thx for that. Yes i'm quite proud of her !!  :laugh: :laugh:
I would imagine they rust from outside in, but i'm taking a guess !!  :wink:

Title: Re: Rusty jacking points
Post by: dubslug on 23 May 2007, 10:51

also had same on mine, had it cut out and new pice welded in, he even added a new jacking point too

Title: Re: Rusty jacking points
Post by: tom26 on 23 May 2007, 11:17

yeah mine was a pain. Found a nice chap to cut out the rust and weld in a plate!
I always apply fresh underseal on the jacking points now after every use, just in case i scratch/crack the old stuff.
don't want a repeat of last time!

Title: Re: Rusty jacking points
Post by: dubslug on 23 May 2007, 11:21

i do the same, mines had alot of work on the underneath, dont wanna do it all again

Title: Re: Rusty jacking points
Post by: dadrathers on 07 June 2007, 22:46

Thanks for all the replies. Had it welded up last week - they did a neat job - 100 squid +VAT.

Given the area a good coat of waxoyl and will top it up regularly.

Title: Re: Rusty jacking points
Post by: dubslug on 09 June 2007, 09:25

good job, just keep eye on it