GolfGTIforum.co.uk
Model specific boards => Golf mk2 => Topic started by: Mart8V on 05 April 2007, 22:40
-
Have found a tilt / slide on a Cordoba which I really like the look of. Will it fit? If I remember Joe was talking about an Audi one on his motor, but a Seat one....?
Here's hoping- please give me some good news!
-
hey bud, i ran a search on yahoo and came up with this little bit of info. hope it helps.
http://homepages.tesco.net/~john.wintle/Sunroof/Sunroof.htm
tbh looking at it i might have a go myself. :grin:
-
Yeah, useful stuff- thanks for that! The one I am looking at has the glass roof (tinted) rather than the panel (which I am quite keen on) but the only bugger is that the headlining and trim in the donor are light so will need to source a winding mech from a Mk3 or something....
-
Go and measure them.. :undecided:
-
It was the mech and runners that were more of the issue than the panel itself, as measurements seem to match, but hoping to get back up to Mr Scrap today......
-
Thing about them is, that the measurements can seem on, but i seem to remember joe having a problem with his being too large. to fit in the roof of the golf. I could be wrong, but it would seem a shame to go through all this and then it be out by a few mm.
-
Totally agree! Will measure up fully when I can get back up there, and if it all matches up will post details of the conversion.
Out of time today. It's either a visit to scrappy or BBQ and Beers this afternoon...... I love my Golf but not that much!
-
I really doubt it would fit straight in, its probably the same as a MK3, passat or Corrado one which wont fit.
The only pannels I know of that are a direct swap are the Scirocco and old square audi 80 roofs!
-
Bugger. Will measure up tomorrow morning but fear you may be right.....