GolfGTIforum.co.uk
General => General discussion => Topic started by: VR6_ROB on 03 December 2006, 11:57
-
hey all
my mk2 gti (pb) has been running spot on since i have had it
but yesterday i got in it after i finished work
and fired her up but it just cut out straight away,
this continued 3 or 4 more times before i could floor it so i could rev it abit
then this morning i fired her up pulled off the drive and it cut out again
did the same thing 3 or 4 times struggled to rev it
started driving and it seemed to die in 5th put it into 3rd and it drove ok again
I have changed the dizzy cap and rotor arm but problem is still there
also in the wet it misfires now and again until its warmed up
dont know if thats anything related to it
cheers
rob
-
rob is this the vr6 lump thats playing up?? sounds common if it is...
-
no its my gti lump in my 4 door
vr6 is problem free at the mo
but it aint on the road until next thursday,
dont want my gti to die on me
could it be plugs or leads?
i changed them in march time
-
plugs and leads look fine
just been out in it and it did it again to me
anything else it could be
-
plugs and leads look fine
just been out in it and it did it again to me
anything else it could be
try rotor arm or dizzy cap, maybe fuel filter have you checked that the leads are not grounding on the head happens sometimes just need to pull the rubber over anyway that's what i would check..
how does it cut out ie does it chug chug then stop or does it just idle low then cut out??
-
Faulty Hall sender or Air Mass Sensor maybe ?! Vacuum Leak ?!
-
i cleaned the idle control valve out
and replaced the breather pipe that goes from the round piece o top of the rocker
as it was split
drives without spluttering but it wont hardly tick over now wants to cut out
and my knock sensor is broken so that could cause it to be ticking its arse off
just bought 20 50 oil see if i can quieten it down
-
get a nock sensor you shoddy git