GolfGTIforum.co.uk

General => Cosmetic and bodywork matters => Topic started by: Jowe-ziff on 29 April 2006, 17:42

Title: Fitting single lights onto quad golf
Post by: Jowe-ziff on 29 April 2006, 17:42

i have a 1.6 '92 driver and was wondering how to fit single lights because i prefer the look but the inner lights are full beam if im not mistaken and the outer ones are just normal lights

how to do i make it all work in one light?

thanks :)

Title: Re: Fitting single lights onto quad golf
Post by: fugazi33 on 29 April 2006, 18:17

Hi there,

the outer lights have dipped and full beam, so you disconnect the wiring to the inner spots, take the grill out and swap in a single light grill, job done, hope this helps.

Title: Re: Fitting single lights onto quad golf
Post by: Uruk Hai on 29 April 2006, 22:08

As said above you just unplug the spotlights and thats it but be aware that you do lose a lot of light when on full beem but if most of your driving is on well lit roads it doesnt really matter

Title: Re: Fitting single lights onto quad golf
Post by: Jowe-ziff on 01 May 2006, 17:03

so basically i jus forget about what the inner lights do and jus wire up the outer ones?

im planning on outting big bumpers on as i only have a driver could i put some bright lights ionto the bumper for when i do actually need them then?


thanks

Title: Re: Fitting single lights onto quad golf
Post by: Uruk Hai on 01 May 2006, 19:20

Yes you could put lights in the bumper, you may be able to get a set of bumpers that allready have fog lights in the front but then you'll have to wire those up

Title: Re: Fitting single lights onto quad golf
Post by: Steve_B on 04 May 2006, 15:44

If you're worried about loss of light the the way to go is an uprated headlight loom and bulbs with a higher power rating.

Title: Re: Fitting single lights onto quad golf
Post by: Veedubgt18v on 04 May 2006, 16:00

and the fog lights arent actually that great compared to the inner spots