GolfGTIforum.co.uk

Model specific boards => Golf mk4 => Topic started by: willz94 on 11 May 2014, 18:01

Title: Ko4 on agu question
Post by: willz94 on 11 May 2014, 18:01

Hi guys not got a mk4 but got a mk3 with an agu 1.8t engine

I have all the items for the conversion only question I have is in regards the inlet, I have the bam inlet manifold that is a small port and the agu head is obviously large port I was just wondering if anyone on here has either port matched the inlet to the head (if so had any problems?) or used a small to large port spacer? If so where can you get one in the uk as I cannot find one anywhere

Thanks for you help !

Title: Re: Ko4 on agu question
Post by: Dalo Harkin on 11 May 2014, 21:27

Surely its just cheaper to get a used AGU inlet manifold

Title: Re: Ko4 on agu question
Post by: Wazzzer on 11 May 2014, 21:46

my guess is the throttle housing needs to be on the passenger side rather than the drivers?

You could look for the very rare early Sharan inlet that has large ports and the throttle mounted on the passenger side or fit some sort of step down adapter if such a thing exists. I doubt there's enough meat on the inlet itself to port it out

Title: Re: Ko4 on agu question
Post by: willz94 on 11 May 2014, 22:36

Found an adapter gasket :) and so I can use the bam inlet, the tt injectors j have don't fit in the agu seats so overall as I got the tt injectors and bam inlet for free it's cheaper to just get the spacer gasket :) thanks :)